Care and Maintenance for your Genuine Biansi eGo-T (Tank) System

BIANSI eGo-T (Tank) Electronic Cigarette/Personal Vaporizer

The Biansi eGo-T (Tank) system is made up of three primary components as illustrated in the photo above.

The Battery is a lithium ion battery. When you first get your kit you should charge your batteries completely. It will take approximately 2 hours to fully charge your batteries. Your battery will last for 2-3 hours of use, depending on your usage habits.

Your batteries are equipped with a 5-click off/off feature. Press the button 5 times quickly within 2 seconds, your battery tip will flash, it will now be off. Press it again 5 times again to turn it back on. The batteries usually ship in the off position.

The Atomizer heats the liquid contained in the cartridge to produce the vapour. When you first get your atomizer you will have to prime it. If you look into the top of the atomizer, you will see a post. One or two drops of liquid on the post will suffice. It is very important to not let your atomizer run dry. Running it dry will burn out your atomizer. When inserting the Cartridge into the atomizer, the post must penetrate the hole in the bottom of the cartridge.

The Cartridge is where you put your choice of vapour liquid. The Cartridge will hold approximately 1.1ml of liquid. To fill the cartridge, you "can" remove the silicone cap on the end of the cartridge and drip liquid directly into the chamber but we recommend using a needle tip bottle to prevent damaging the end cap. Continue filling the cartridge until the chamber is approximately 3/4 full.

The Charger “pig tail” can be plugged into a USB port on your computer or into the USB wall adapter that plugs into your household outlet. When connecting the battery to the charger it should be snug but do not over tighten. When you feel it stop that is good. The light on the charger will turn red and remain red while it is charging your battery. Once fully charged it will turn green. Charging generally takes about 1.5-2.5 hours on the wall charger but could take longer when connected to computer or other USB port. These batteries do not have a memory and will not overcharge. They can be left on the charger overnight without concern.

Care and Maintenance - This is an electronic device; do not use water to clean any of the electrical connectors. Every day, clean the atomizer threading, the battery threading and the inside threading on the charger with a piece of dry paper towel. Keep all components out of the reach of children, and pets.

Additional Questions - Please do not hesitate to contact us if you have any additional questions or concerns about your device. Just send us an email us at and we will do everything we can to assist you. Your success is our success.