
Kanger Horizontal Coil Cartomizers
Remove the rubber ends from the cartomizer. Remove the white cap from the end of the cartomizer. This can be done with a toothpick or kitchen fork, etc. Inside, you will see the white, dry poly-fill material with a whole in the center which goes through to the base of the cartomizer.
Tilt the cartomizer slightly and drip your vapour liquid directly into the poly-fill material. You should avoid getting any liquid in the whole.
Continue filling until the liquid begins to puddle on top of the poly-fill. Clear any excess liquid by blowing into a paper towel or tissue from the bottom of the cartomizer to expel the liquid out the top. Replace the white cap or 510 Drip Tip (not included) and attach to your battery.
When to RefillThe cartomizer should be refilled or “topped off” when you notice a change in flavour.
When to DiscardThese are disposable units and they should be discarded when the vapour production becomes weak. The life expectancy is approximately 1 week.
NoteThe coil is located at the bottom. Ensure that it is completely full of liquid before using.
Additional QuestionsPlease do not hesitate to contact us if you have any additional questions or concerns about your device. Just send us an email us at and we will do everything we can to assist you. Your success is our success.